This is a relay board designed to be controlled via a 5 volt micro-controller. It can handle loads of up to 10 Amps at 250 volts

Marshall VSX0097-SE Single chip CMOS Color Video Camera With Audio

Center tapped 10K Potentiometer wire block connector

Micro Maestro 6 Channel USB Servo Controller

This USB controlled micro-controller kit features the powerful Microchip PIC18F13K50 chip. It uses all through-hole components which makes soldering and assembling it simple.

This fully-assembled pan-tilt is the perfect way to give your project full range motion with two micro servos. The pan-tilt can rotate roughly 180° from side-to-side and can tilt up&downwards around 150°. It also comes fully assembled with two Micro Servos (SG-90 or SG-92 type) included and a 38mm x 36mm space to mount a camera or sensor or whatever you like.

The Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the board for a few dollars and start over again. "Uno" means one in Italian and was chosen to mark the release of Arduino Software (IDE) 1.0. The Uno board and version 1.0 of Arduino Software (IDE) were the reference versions of Arduino, now evolved to newer releases. The Uno board is the first in a series of USB Arduino boards, and the reference model for the Arduino platform.